Hello, as i have lost all my SWS-SAG cables , i only have the box and i need to build the cables to get it working again, mainly the MYX-x cable (the most used) so i´m needing the pinout of the BOX (3 cables go to the phone, and 4 goes to the RJ45 JIG adapter) so i need this information, i have searched all over and found nothing about this.....only testpoint pinouts.....Thanks

RJ45 PIN 1 AND RJ45 PIN8=GND GOES TO PHONE CONNECTOR
RJ45 PIN2=TEST POINT
RJ45 PIN3=TEST POINT
RJ45 PIN4=RX GOES TO PHONE CONNECTOR
RJ45 PIN5=TX GOES TO PHONE CONNECTOR
RJ45 PIN6=TEST POINT
RJ45 PIN7=TEST POINT

Even when making the cable this way, the normal communication with phone is working well because it reads common data like IMEI , User Code..and so . BUT the testpoints part is not working, it always stops at 20 % like if the testpoints were not connected, i think that maybe the testpoint outs from the box are not working well....anyone knows how can i test this ???? wich voltage must be on each pin ? if it is a DC voltage or it´s a pulse signal ??? :confused: :( :confused: ...i´m lost, and i have no way of buying a new cable :( ...julvir still visits our forum?

look cuban0,pin 1 or 8 must be connected to earth of phone and it wont stop at 20%.Am not in the office now otherwise i will have been able to be precise,but dont be afraid it wont damage anything.Tested by me