I have a Sprint CDM8912 that I've been trying to flash to Cricket with no luck. I have Unified PST but it's for Verizon phones. Has anybody had any luck with this? I'm using a usb cable. The phone indicates that it's charging when I plug it into the usb port, but none of the software will detect the phone. I am also using the DataPilot/Susteen cables which is why the phone will charge when it's plugged into my laptop. I have already changed the phone's port settings using ##7678 end. I have also changed the baud rate using ##2283 end. Any help would be greatly appreciated. If there's some specific software I should be using, I'm all ears.

Thanks in advance.

well you need a com cable that is how i do them then just use cdma workshop and your good to go i dont even use usb cables anymore for any phone it is tomuch of a pain with 20 usb cables and 30 com ports to mess with

I just needed to dig through my device manager a little and re-install some drivers. Sorted it right out. I don't even have any serial cables to work with. Thanks again.

So if you are not using cables what means are using to flash the phones?

So if you are not using cables what means are using to flash the phones?

What I meant to say was I don't have serial cables, just usb cables. I'm too lazy to solder together any serial cables and too cheap and lazy to buy any serial cables. Customers have actually brought me all of my usb cables that I use for flashing.