I have a trium geo ! It was dead I flashed it then it said mobile malfunction ! I wrote a eeprom file 16 kb ! now it says Enter unlock code tried each and every software for Trium phones from many forums ! but it dose not shows unlock code ! in unlock code box in software it sahows ???? its 4 times question marks ! I again loaded the eeprom files same problem ! I have downloaded an eeprom file which is 8 kb size when I load this file phone says mobile malfunction contact provider ! the picture of mobile is on this site !
[Only Registered Users Can See Links]

and on the back side of phone under the battery in Imei sticker it written model no. is Mt - 345 GEO @ i

Try removing first the error Contact Provider...

Unlock Code can be done using WinHex by changing OffSet 0000128D to 31323334 Hex Value...

Just Read ur 16kb EEPROM then save it...Open ur Extracted file with any HEX Editor then Patch it...

After saving modification with file...Write the file back to ur GEO Phone...

When ask for the Unlock Code, just enter 1234...

Gudluck...

use ms tools. Its verry usefull and unlocking is 100% tested on that model

Thank u tushar ! but freind I have used many softwares from many sites some of them says phone is unlocked and some of them reads the code like this ???? it means fours time Question marks ! still no solution !

contact me.. i will give u proper flash+eeprom.. just write them all will be OK

(Files are not on this laptop otherwise i would have uploaded them here.. but will do it later)

WBR
Syed

Hi Syed !!!


Its Better to Upload it Here !!! ;)

yea syed. we all know your just great. so please upload here.