COM28 [VCP0] selected
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
eeprom backup enabled, it may takes several minutes !
Action: read/check detailed information
Boot...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing[6226:8A02:8A01]...
CPU: MT6226
high speed boot disabled
chip: 0031:A765:FA73
high speed disabled
boot step size: 0002
Release Power button now !
Boot Done
Initialize...
detecting chip #00 in region #00...
flash: 89881500010001:89881500000000
flash: 89881500010001:89881500000000
flash: Intel 128MBit-B Strata B 16Mb
detecting chip #01 in region #00...
flash: 89881500010001:89881500000000
flash: 89881500010001:89881500000000
flash: Intel 128MBit-B Strata B 16Mb
number of flash chip/regions detected: 02/01
Initialize Done
Set baud...
460800
Set baud Done
Initialize bootcode...
Initialize bootcode Done
Check firmware integrity...
device parameters autodetection in progress..
detecting chip #00 in region #00...
flash: 89881500010001:89881500000000
flash: 89881500010001:89881500000000
flash: Intel 128MBit-B Strata B 16Mb
detecting chip #01 in region #00...
flash: 89881500010001:89881500000000
flash: 89881500010001:89881500000000
flash: Intel 128MBit-B Strata B 16Mb
it's time to stop: 290000EA18F09FE518F09FE518F09FE518F09FE518F09FE5
number of flash chip/regions detected: 01/01
total flash region size: 01000000
detect device identification#1...
detection phase #1...
.
detection phase #2...
................................................................................................................................
warning: identification#1 information not found, possible reasons:
.old firmware type w/o identification#1 data
.damaged firmware
.damaged hardware
if phone works fine just ignore this warning
detect device identification#1 finished
detect device identification#2...
detection phase #1...
.
warning: optional information not found,
if phone works well just ignore this warning
detect device identification#2 finished
detecting eeprom/ffs area in 1 chip(s)...
standard eeprom/ffs offset assigned: 00E00000
flash: 89881500010001:89881500000000
flash: 89881500010001:89881500000000
checking area[00000000]: 00000000-00FFFFFF...
Can't detect eeprom/ffs area
Do you want to use standard ffs address: 00E00000 ?
If you are not sure that standard address is correct:
1. press "NO" and terminate current operation
2. make flash backup for emergency case
3. repeat required operation
standard ffs address selected by user
detecting eeprom/ffs size...
eeprom/ffs size: 00200000
ffs chip: 00
eeprom/ffs area: 00000000:00E00000-00FFFFFF
detecting ffs structure pass 1...
........................................................
can't detect fat record name location
ffs element #1 detection failed
detecting ffs structure pass 2...
........................................................
can't detect fat record name location
ffs element #2 detection failed
Check firmware integrity Done
Check firmware content...
detecting firmware version...
................................................................
................................................................
firmware version: _S01.M_RF4210008_M01_GPRS_MT6226_S01.M_RF4210008_M0
Check firmware content Done
Backup required data...
Finished, time used: 183 sec
Remove/Install battery now !