E51 в локал входит а check нет

[Xxoma]

Подключаю через x-Fbus кабель, при на нажатии check: Error sync the phone... Info все нормально считывает. Пробовал и джафом и уфс. Кабель нормальный, прозванивал по схеме с форума. В чем может быть проблема?

[Xxoma]

Скрытый текст: Показать

MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
APE Variant file: NONE
Switching to serial...
Powering the phone...
Reading...
MCU SW version: V 200.71.814
09-04-08
RM-244
(c) Nokia
HW version: 0803
PCI version:
RFIC version:
DSP version:
Retu version: 15
Tahvo version: 22
Production serial number: SCO485693
Product code: 0561220
Module code:
Basic production code: 0545341
Flash code:
Order number:
Product specific data:
Long production SN: 0
ATO:
Default SN type:
IMEI plain: 356795024754595
IMEI spare to net: 3A 65 97 05 42 57 54 09
IMEI SV to net: 33 65 97 05 42 57 54 29 F0

LOCK STATUS:

CONFIG KEY: 0000000000000000
PROVIDER KEY: 2440700000000000
Provider: AT&T;U.S.A. (3650)
Key Code count: 0, FBUS Code count: 0

Block 1:
Lock 1: OPEN Lock 2: OPEN Lock 3: OPEN Lock 4: OPEN Lock 5: OPEN
Block 2:
Lock 1: OPEN Lock 2: OPEN Lock 3: OPEN Lock 4: OPEN Lock 5: OPEN
Block 3:
Lock 1: OPEN Lock 2: OPEN Lock 3: OPEN Lock 4: OPEN Lock 5: OPEN
Block 4:
Lock 1: OPEN Lock 2: OPEN Lock 3: OPEN Lock 4: OPEN Lock 5: OPEN
Block 5:
Lock 1: OPEN Lock 2: OPEN Lock 3: OPEN Lock 4: OPEN Lock 5: OPEN
Block 6:
Lock 1: OPEN Lock 2: OPEN Lock 3: OPEN Lock 4: OPEN Lock 5: OPEN
Block 7:
Lock 1: OPEN Lock 2: OPEN Lock 3: OPEN Lock 4: OPEN Lock 5: OPEN

Searching for saved ini...
Checking for file C:\Program Files\ODEON\JAF\JAF_RM-244.ini
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
APE Variant file: NONE
Done![/QUOTE]

[guron]

кабель (резистор BSI)

[Xxoma]

если бы резистор то в локал не входил бы.

[Xxoma]

Уже разобрался, все таки кабель хреновый был.