FN5258 не включается.

[darkzerro]

Принесли телефон на русский. Хинтелом был слит фулл, после зарусен. После чего захотели снова востановить первоначальное ПО:

Хинтел не захотел шить:
----------------
open comport:COM6
please turnon your phone ,until connect success(press F4 Abort).
connect to Phone.
CPU model :6223 ( HW_VER: 8A05 )
download Boot ...
boot File Ver.:04.02
flash manuf. maybe :SAMSUNG
NOR flash model :
NOR flash size:01000000 (16.0M)
NOR flash ID code :00EC2402 (00000000) [164]
Int.RAM size:0000A000 (0.40M)
Ext.RAM size:00400000 (4.0M)
Bootloader in [NOR] flash
Read flash information operation done!
baud set:460800
analyze flash ...(algorithmic[A])
decryption fail1 D74
analyze flash ...(algorithmic[B])
this File not decrypt data ...
analyze flash ...(algorithmic[C])
not found address bit. 1
analyze flash ...(algorithmic[D])
decrypt flash fail.07
decryptfail,write origin flash files ,
flash size:01000000 (16.0M)
write flash...
Write Error ! :00000000
>>operation done.

FlashTool 03.9.32 - прошил, но телефон перестал включаться.

Infinity log repair:
==== log: [24.11.2009 19:40:35] ====
COM6 [ProlificSerial0] selected
module v3.00
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
Action: repair "bad software" (mode-1)
====> Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6223:8A05:8A00]...
CPU: MT6223
high speed boot On
chip: 0011:8372:000C
status: FF
boot packet size: 0400
Release Power button now !
Boot Done
====> Initialize ...
detecting chip #00 in region #00...
flash: EC240200000000:2BEA0000000000
flash: Samsung K5L2833ATA T 16Mb
detecting chip #01 in region #00...
flash: EC240200000000:2BEA0000000000
flash: Samsung K5L2833ATA T 16Mb
detecting chip #02 in region #00...
flash: EC240200000000:2BEA0000000000
flash: Samsung K5L2833ATA T 16Mb
detecting chip #03 in region #00...
flash: EC240200000000:2BEA0000000000
flash: Samsung K5L2833ATA T 16Mb
number of flash chip/regions detected: 04/01
Initialize Done
====> Set baud ...
115200
Set baud Done
====> Initialize bootcode ...
Initialize bootcode Done
====> Check firmware integrity ...
device parameters autodetection in progress...
detecting chip #00 in region #00...
flash: EC240200000000:2BEA0000000000
flash: Samsung K5L2833ATA T 16Mb
detecting chip #01 in region #00...
flash: EC240200000000:2BEA0000000000
flash: Samsung K5L2833ATA T 16Mb
it's time to stop: 2B0000EA18F09FE518F09FE518F09FE518F09FE518F09FE5
number of flash chip/regions detected: 01/01
total flash region size: 01000000
searching rom info...
search rom info finished
rom info structure: 2nd [enhanced] generation
TCL-ID is absent
startup code area #1 is damaged, recalculation required
rom info detection finished
device-id: 3CCEE8F3
rom info protocol ver: 04
ver. sw 1: MX701A_HYF_NTP_128_PCB01_GPRS_MT6223P_S00.V1_00_02 _M090703CN0-V22.BIN
ver. sw 2: V1.00.02_M090703CN0-V22, CB497890
address offset: 00000000
ffs offset/size: 00B60000/004A0000
detecting licence parameter...
detecting licence parameter name...
phase #1...
.................................................. ..............
phase #2...
.................................................. ..............
done
error: licence parameter licence parameter name is not found
What to do:
1. Be sure that your phone really has "bad software" problem, in other case do NOT use "bad software" button !
2. Repeat "bad software" operation several times to avoid communication problems.
3. Flash phone with firmware from support area and repeat "bad software" operation.
If still no luck:
1. read full flash and send to support:
2. send "operation.log" file to support:

file saved: C:\Program Files\InfinityBox\ChineseMiracle\backup_security\_ system_log_3CCEE8F3_907849CB_20091124-194204.B0X.bin
Finished, time used: 70 sec
Remove/Install battery now !



У кого есть такой фулл или телефон. Дайте фулл слитый FlashToolом или Infinity. Надо бы поднять тело.
Фулл слитый Хинтелом прикладываю, может его кому получится поправить для востановления.

MX701A_HYF_NTP_128_PCB01_GPRS_MT6223P_S00.V1_00_02 _M090703CN0-V22.rar
http://www.rapidshare.ru/1266577

[Дима 2006]

Хинтел , вроде, немекает что не может подобрать дескриптор и тел может не включиться (бэкап надо было делать Инфинити!!!) ! Можно попробовать в Инфинити сделать "репайер", а не "восстановление" . Можно попробовать вручную найти в прошивке "сек.зону" и восстановить в Винхексе или искать фул слитый Инфинити.