Repair Imei i9300 z3x uart emulating C3300K Cable with volcano Sponsored Links
Repair Imei i9300 z3x uart emulating C3300K Cable with volcano
If by chance they damage the cable or C3300K uart z3x when bought not brought that wire, easy now no need to buy more cables uart
The volcano has q box is more than enough
See pictures at end of post
Repair imei with z3x version 13.6, either by selecting the model i9100 or i9300 (sometimes does not come enabled with the i9300 Repair button, so with the i9100 model serves well)
Open volcano box and go to the tab DETECT .. and table pinout, adjust the following
1: VCC, 2: rx. 3: tx, 4: Korea, 5: gnd and pin 5 on it, put the "reb" and asked to write down the value of the resistance
In this case is 510 and do OK and then SET PINOUT ready again to z3x ...
In comport, mark which is assigned its volcano, in my case, above on com3 repair (usb modem and com port)
Mark in "com port", starting the process, with regular USB cable and USB debugging enabled, no need to select the modem, since it automatically detects (must have rooteado your s3)
Then they click Repair button and mark what they need, imxx, s / n, product code (depends on what you need to repair or may not match the label, or only as in my case imxx and tick repair efs). .. OK mark and start the repair.
Then when it appears in the log "rebooting phone .. ok" disconnect the USB cable ... and connect the cable from the volcano with the point P-05B (only that far, not yet connect the cable to the volcano) when you turn the phone write * #9090 # and select option 2
Right there, reset the phone, (mark off button and restart)
Once on again, pay attention to the z3x log that says "checking phone at COMx" and there connecting cable 26 to the volcano should immediately proceed with the repair and what they have marked.