Samsung S5230, заряжали на прямую к контактам акб. Было потребление в выключенном состоянии, поменял КП- потребление ушло. При включении тело заводится, потребление тока 700мА примерно, жутко греется проц. В Этом состоянии пытался слить с него фулл riff-ом, не вышло нет коннекта. Заменил проц. При попытке включить, на блоке 0,04-0,07мА. Думал прошивка проца и флеш не совпадает, поцепил к riff если стереть-пишет такесли востановить пишет такКод:Firmware Version: 1.34, JTAG Manager Version: 1.48 Selected Resurrector: [Samsung S5230 V1.00] Connecting to the dead ************...OK Detected dead ************ ID: 0x07926F0F - CORRECT! Set I/O Voltage reads as 2.99V, TCK Frequency is RTCK Adaptive Clocking RTCK Sampling is: [Sample at MAX] Settings Code: 0x05010000000000000000000010000000 Resurrection sequence started. Establish communication with the phone...OK Uploading resurrector data into memory...OK Starting communication with resurrector...FAILED ERROR: Wrong DCC data checksum.Что хочет тело примерно, куда глядеть еще?Код:Open serial port...OK Connecting to the RIFF Box...OK Firmware Version: 1.34, JTAG Manager Version: 1.48 Selected Resurrector: [Samsung S5230 V1.00] Connecting to the dead ************...OK Detected dead ************ ID: 0x07926F0F - CORRECT! Set I/O Voltage reads as 3.00V, TCK Frequency is RTCK Adaptive Clocking RTCK Sampling is: [Sample at MAX] Resurrection sequence started. Establish communication with the phone...OK Uploading resurrector data into memory...OK Starting communication with resurrector...FAILED ERROR: Wrong response from the resurrector code: 0x4B47