Panas KX-TC 1070 регистрация ???

[Mroma]

В инструкции пользователя должна быть регистрация.

[Rendi]

Подскажите как зарегистрировать трубку на базе ?
Может кто сталдкивался ?

[Rendi]

в инструкции такого нету.
Труба была разбита .. и полностью вышла из строя.. чтобы зарегистрировать новую надо воспользовать сервисным меню и кодами.. которых в обычной доке нету. Нуне Service Manual .. может есть у кого ?

[Rendi]

up

[mexanic]

на 48 стр.инструкции нажимаешь прог. пока два раза бип бип и мигает индикатор.Затем вкл трубку в режим регистрации.Успеха.

[loadcom1]

Mroma
<Writing Procedure>
Install the option diode DS13 to the base unit and turn the power ON.
- The base unit enters the RX waiting mode at the special channel
(As for the special channel, refer to 12 FREQUENCY TABLE (MHz).)

Insert the battery into the portable unit while pressing the keys of 2,7 and # at the same time. "ID code write" is displayed on the LCD of the portable unit.
Press the TALK button of the portable unit. The portable unit and the base unit are linked at the special channel. (As for the special channel, refer to 12 FREQUENCY TABLE (MHz))
Press the ID CODE of 5 digits using the decimal system from the portable unit according to ID of the ID label. ID = 00000~65535
Press the TALK button of the portable unit.
- The portable unit transmits the ID writing request data.
- When the base unit receives the data, a new ID is written in the EEPROM of the base, then it transmits "ID confirmation data" to the portable unit.
- When the portable unit receives the data, the ID is written in the EEPROM of the portable unit, then the confirmation tone will sound.
Note: When ID writing is failed, the error sound will be output. At the same time, RF block and EEPROM of the base unit and the portable unit should be checked.
Turn OFF the power of the base unit, and then remove the option diode DS13. Charge the portable unit.
Turn ON the power of the base unit then confirm the LINK.

[Rendi]

loadcom1
огромное человеческое спасибо !
Буду пробовать !