Всем привет!
Имеется такой автомобильный телефон. При включении без карта пишет "phone failed - see supplier". При включении с мастер картой спрашивает ПИН, код телефона (спрашивал, но после ввода правильного кода телефона - перестал) и после ввода ПИНа опять пишет "phone failed - see supplier". В тест мод не входит, для выполнения следующих операций:
The test card can actually be used to make the phone recalculate the configuration checksum at $0000-$0001 after you have manually edited the EEPROM data. After powering up the phone it will go: "phone failed - see supplier" on the display. By updating the PA calibration table, the configuration checksum will be recalculated.
Enter testmode by holding # down
Type 0205# - get answer (eg. 75)
Type 0205075# (just write the same value again)
Type 01# (to leave test mode)
The phone still says "phone failure..."
Turn phone off and on again - "Insert SIM" DONE!!!

Внутри М27С4002 и АТ28С64.
Как его разлочить, плз?