mazduk
24.06.2004, 19:09
Вот нашел! Кому интересно!
Предварительно подать на пин 1 системного разъема +5 вольт это зарядка При подключении кабеля она должна индицироваться! Затем:
Solution is:
A) Get the correct code (This is another story)
B) Make a backup of field 268
C) Edit field 268 to 00 00
D) Take out the battery for some seconds (to be shure :-))
E) put a SIM inside the phone
F) (Do not power on the phone) Load the battery for some seconds and take out the charger again...
G) In the display should be the animation "Stop active"
H) connect the datacable and write the original value to field 268
(During all this the message "Stop active must be visible on the display"
I) Power on the Phone. It will ask for the PIN and then be simlocked. You can enter the correct code now
Сам пока не пробовал Но народ утверждает что все работает на myx5m точно и вроде на myx6! Поля считывать по видимому сажем доктором! Пойду эксперементировать!!! Ежли чего давайте опсудим!
Предварительно подать на пин 1 системного разъема +5 вольт это зарядка При подключении кабеля она должна индицироваться! Затем:
Solution is:
A) Get the correct code (This is another story)
B) Make a backup of field 268
C) Edit field 268 to 00 00
D) Take out the battery for some seconds (to be shure :-))
E) put a SIM inside the phone
F) (Do not power on the phone) Load the battery for some seconds and take out the charger again...
G) In the display should be the animation "Stop active"
H) connect the datacable and write the original value to field 268
(During all this the message "Stop active must be visible on the display"
I) Power on the Phone. It will ask for the PIN and then be simlocked. You can enter the correct code now
Сам пока не пробовал Но народ утверждает что все работает на myx5m точно и вроде на myx6! Поля считывать по видимому сажем доктором! Пойду эксперементировать!!! Ежли чего давайте опсудим!