Sportster
14.04.2011, 15:58
Привет всем
нужна помощь в работе с RIFF не магу поднять принесли тел не включается вообще подпоясался восстановил пда на нем вот лок
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.22, JTAG Manager Version: 1.30
Selected Resurrector: [Samsung i900 PDA]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x2E649013 - CORRECT!
Set I/O Voltage reads as 3.29V, TCK Frequency is 10 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip ID: 0x00EC/0x0040 (256MB)
Flashing the dead ************...OK
Resurrection complete!
стал включатся но на заставки висеть
подпоясался начал модемную часть восстанавливать результат выкинула
Connecting to the dead ************...ERROR
ERROR: The RTCK Signal does not respond.
и все жесть при этом греется может что-то не то с железом
нужна помощь в работе с RIFF не магу поднять принесли тел не включается вообще подпоясался восстановил пда на нем вот лок
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.22, JTAG Manager Version: 1.30
Selected Resurrector: [Samsung i900 PDA]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x2E649013 - CORRECT!
Set I/O Voltage reads as 3.29V, TCK Frequency is 10 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip ID: 0x00EC/0x0040 (256MB)
Flashing the dead ************...OK
Resurrection complete!
стал включатся но на заставки висеть
подпоясался начал модемную часть восстанавливать результат выкинула
Connecting to the dead ************...ERROR
ERROR: The RTCK Signal does not respond.
и все жесть при этом греется может что-то не то с железом