PDA

Просмотр полной версии : Other Ошибка при восстановлении ZTE MF190



ajab_ctt
24.06.2011, 11:23
Модем принесли мертвым, по словам клиента умер при прошивке.
Вот лог:


Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.25, JTAG Manager Version: 1.33
Selected Resurrector: [USB Modem MF190]

Connecting to the dead ************...OK
Detected dead ************ ID: 0x301C00E1 - CORRECT!
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Uploading resurrector data into memory...OKFAILED
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
ERROR: No response from the DCC Loader. Terminating.

Так же проверил на вкладке Usefull Plugins

Resurrection sequence started.
Establish communication with the phone...OK
Uploading resurrector data into memory...OKFAILED
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
ERROR: No response from the DCC Loader. Terminating.

Checking which Partition is blank...COMPLETE!
Following partitions are found to be completely blank:
Partition: SIM_SECURE at 0x00028000..0x0003FFFF (0x000A..0x000F)
Partition: OEMSBL2 at 0x0009C000..0x000E3FFF (0x0027..0x0038)
Partition: FOTA at 0x01778000..0x01893FFF (0x05DE..0x0624)
Partition: FTL at 0x01894000..0x01993FFF (0x0625..0x0664)


Все частоты уже испробовал, не помогает.
Какие есть советы?