Nokia 202 RM-834 ищется файл конфигурации камеры

[darkzerro]

Nokia 202 RM-834 ищется файл конфигурации камеры

Лог с MX-Key:


Phone type: RM-834 (202)
SW version: V 20.36 24-05-12 RM-834 (c) Nokia
Imei plain: 351668........
Product code: 059M606
Battery voltage: 4177 mV, current: 0 mA
Cellular system: GSM
ASIC ID: 0x0000, type: 11
Ppm Id: I
Language Pack:
- not available.

Camera config: 115B6002XXXXXX, ver:

Imei net: 351668.........
Version: SIMLOCK SERVER
Provider: GSM Test Operator
Counter: 0/3, 0/10

CONFIG_DATA: 0010100000000000
PROFILE_BITS: 800000000003000B

BLOCK1: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK2: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK3: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK4: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK5: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK6: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK7: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN

[DimaTi]

Если актуально ещё:

[deezee]

Подниму тему - один в один ситуация:


Phone type: RM-834 (202)
SW version: V 20.52 27-09-12 RM-834 (c) Nokia
Imei plain: 354609хххххххх
Product code: 059N1J7
Battery voltage: 3725 mV, current: 160 mA
Cellular system: GSM
ASIC ID: 0x0000, type: 11
Ppm Id: I
Language Pack:
- not available.

Camera config: 115B6002XXXXXX, ver:

Imei net: 354609......
Version: SIMLOCK SERVER
Provider: GSM Test Operator
Counter: 0/3, 0/10

CONFIG_DATA: 0010100000000000
PROFILE_BITS: 800000000003000B

BLOCK1: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK2: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK3: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK4: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK5: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK6: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN
BLOCK7: 1=OPEN, 2=OPEN, 3=OPEN, 4=OPEN, 5=OPEN


При попытке записать файл конфигурации:
No dcc found from datapackage directory.
Scanning dcc on local storage ...
Writing DCC ...
Camera Configuration file write failed !
Trying to write DCC as PM ...
DCC write as PM failed !

Cyclone-box:


Analyzing Dynamic Camera Configuration...
[Nokia Asha 203 USB Phonet]: Port opened OK!

--> Primary Camera Not Exists

Secondary Camera: 115B6002XXXXXX
Secondary Camera Configuration is destroyed, writing factory one...
Configuration file not exists, Contact Support to obtain one!

Dynamic Camera Configuration Analyze/Repair Finished!


Selftest


Passed ST_SIM_LOCK_TEST
Passed ST_SECURITY_TEST
Passed ST_PWR_KEY_TEST
Passed ST_CURRENT_CONS_TEST
Passed ST_LCD_TEST
Passed ST_LPRF_AUDIO_LINES_TEST
Passed ST_LPRF_IF_TEST
Passed ST_KEYBOARD_STUCK_TEST
Failed ST_CAMERA_IF_TEST
Passed ST_BT_WAKEUP_TEST
Passed ST_HOOKINT_TEST
Passed ST_BTEMP_TEST
Passed ST_RF_ANTENNA_TEST
Passed ST_CDSP_PA_TX_POWER_TEST
Passed ST_SLEEP_CLOCK_FREQ_TEST
Passed ST_KEYB_LINE_TEST
Passed ST_ADC_IF_TEST
Passed ST_MEMORY_CARD_IF_TEST
Passed ST_TOUCH_STUCK_TEST
Passed ST_TOUCH_IF_TEST
Failed ST_SIM_MULTIPLEXER_IF_TEST
Passed ST_RF_PLL_TEST
Passed ST_FEM_CURRENT_TEST
Passed ST_SECURITY_FUSE_TEST
Selftests done, Tests total: 24, Tests passed: 22, Tests not passed: 2

Т. е. не совсем понятно: по логам - софт, по селфтесту железо, или... помогите разобраться. Если правильно понимаю, то если в ТА отсутствует файл конфигурации камеры, то в селфтесте будет failed, или ошибаюсь?