mak
13.01.2015, 21:08
Аппарат не включается. Потребление подскакивает до 80 мА и падает.
Ресурект проходит удачно.
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [HTC OneS (PJ4020000) V1.0.4926.47132]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x204210E1 - CORRECT!
Set I/O Voltage reads as 1.82V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (K3U00M, 0x0003A3E00000 Bytes = 14.56 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (K3U00M, 0x000000200000 Bytes = 2.00 MB)
Flashing the dead ************...OK
Resurrection complete!
но ситуация не изменяется. при подключении по УСБ определяется как qualcomm hs-usb qdloader 9008
Re-partition eMMC делал. Во вложении считанный Load Layout from Device
Искал фулл - не нашел.
С Рифом работал мало, может чего упустил. Требуется помощь клуба.
Ресурект проходит удачно.
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [HTC OneS (PJ4020000) V1.0.4926.47132]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x204210E1 - CORRECT!
Set I/O Voltage reads as 1.82V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (K3U00M, 0x0003A3E00000 Bytes = 14.56 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (K3U00M, 0x000000200000 Bytes = 2.00 MB)
Flashing the dead ************...OK
Resurrection complete!
но ситуация не изменяется. при подключении по УСБ определяется как qualcomm hs-usb qdloader 9008
Re-partition eMMC делал. Во вложении считанный Load Layout from Device
Искал фулл - не нашел.
С Рифом работал мало, может чего упустил. Требуется помощь клуба.