Простой вопрос, на ерикссон т28 нужна распинвка разъема хэндсфри там где когда-то был разъем для подключения микрофона клиент уложил кучу олова, это дело снял вместе с деталями.
Простой вопрос, на ерикссон т28 нужна распинвка разъема хэндсфри там где когда-то был разъем для подключения микрофона клиент уложил кучу олова, это дело снял вместе с деталями.
нашел.
| 1 2 | 3 4 5 6 7 8 9 10 11 | 12 |
---------------------------------------
1 - AFMS, Out, Audio from mobile station (external speaker, very small signal 10 mV).
2 - ATMS, In, Audio to mobile station (external microphone).
3 - EXTAUD, In, External Analog Audio Accessory Sense (enable external mic and speaker,
connect to GND to do so).
4 - GND, Audio Signal Ground, 0V reference
5 - PORTHF, In, Portable Handsfree (Enable external mic and speaker, connect to GND to do so).
6 - MUTE, Out, Music Mute (Digital output. High when calling. Could be off-hook signal).
7 - VPPFLASH, In, Flash Memory Voltage and Service Voltage (Digital Input.
Phone enters debug mode when tied to +5V at power-up).
8 - VDD, Out, Logic Reference, Status ON (+5V out ? Sources over 100mA).
9 - TFMS/DFMS, Out, Terminal Adaptor Equipment From Mobile Station/Data From Mobile Station
(Serial output. Debug messages appear here at 112KBaud when in debug mode).
10 - GND, Digital Ground and DC Return
11 - TTMS/DTMS, In, Terminal Adaptor Equipment To Mobile Station/Data To Mobile Station (Serial input).
12 - DCIO, In/Out, DC positive pole for phone battery charging and external accessory powering (Charger plus).
А вот наглядней:
http://www.kartridgi.nm.ru/Handsfree_new_eric.jpg