COM53 [VCP0] selected
module v3.15
Device: Autodetect 6228-6239 NAND
Checking data, wait...
Action: write flash NAND
write: Firmware
E710_JJF1WQVGA1_PCB01_GPRS_MT6235B_S01.01_0__firmware_20100616-162749.B4M.bin
skip: Customization/Language Pack
skip: Customization
skip: Eeprom/ffs
nfi area detection...
external bootloader is not present
bootloader version: E710_BOOTLOADER_V005_MT6235B_01_1.bin
nfi area detection finished: Ok
interface: BROM_DLL_v3.1012.00
Connect...
Phone should be Switched OFF !
Press and HOLD Power button now !
Connecting...
Booting...
Release Power button now !
bootcode current/expected: 3.2/3.2
CPU: 6235:8A04:8A01
status: FF
bbchip bl ver: FE
NOR flash chip: not installed
NAND flash id[0058]: 002C:00A100800095 [MICRON] MT29F1G08ABB
chip size: 128Mb
page/spare size: 0800/0040
pages per block: 0040
bits i/o: 08
address cycles: 04
internal RAM size: 00010000
external RAM: S_DA_RAM_ERROR
done
Set baudrate (921600)...
done
ram test...
testing...
ram test passed
===> detect existing firmware structure...
detect ffs...
detect sec ro...
detect custom parameters...
detect project-id...
detect NAND info...
number of areas/bytes to read: 1:001A0000
reading (HW_STORAGE_NAND NUTL_READ_PAGE_ONLY)...
nfi area detection...
warning: header is empty: probably flash chip completely erased
warning: can not detect header
nfi area detection finished: failed
warning: ffs can not be detected
TCL-ID detection...
TCL-ID detection done
startup code area #1 detection...
startup code area #1 detection done
code offset: 00000000
===> done
nfi area detection...
external bootloader is not present
bootloader version: E710_BOOTLOADER_V005_MT6235B_01_1.bin
nfi area detection finished: Ok
startup code area #1 check...
startup code area #1 fixed
number of cores: 3
loading files...
number of areas: 3
done
write...
error: can not write flash: 0BC0:S_DA_DEVICE_NOT_FOUND
error: last error: 0BC0:S_DA_DEVICE_NOT_FOUND
Disconnect...
done
Finished, time used: 1 min 30 sec
Remove/Install battery now !