Инвертированы обе оси. Трабла возникла после форматирования. После калибровки в режиме mode-auto тач вообще отказывает. То есть реакция на нажатие (вибро) есть, но только и всего. В других режимах калибровка вообще не проходит:
Была версия E706_GXT5LATWELV18_PCB01_GPRS_MT6235B_S01.01_0
Залил E706_GXT3LATWMANV18_PCB01_GPRS_MT6235B_S01.01_0__WG3_128m саппорта. То же самое.
Код:
COM4 [VCP1] selected
module v3.15
Action: touchscreen calibration
mode: 1
Calibration order: reverse
Model: Autodetect 6205-6239 NOR
Checking data, wait...
Phone should be Switched OFF !
Press and HOLD Power button now !
19200 autodetect
Initializing [6235:8A04:8A01]...
CPU: MT6235
high speed boot On
chip: 0000:0000:0003
status: FF
rom: 4D573031
Connecting at 19200, wait...
Release Power button now !
Phone detected, wait...
Hardware: MT6235,E04
Date: 2000.00.00
Version: 1.0
Version: E706_GXT3LATWMANV18.01.0
Version: EVEN35_08B_HW
detecting structure #2...
1 4 5 7 8 9 11 12 done
87 byte(s) read
imei: 6071338025xxxx
connection Ok
detecting structure #5 (mode-1)...
18 16 15 13 12 8 6 5 3 2error:
detection failed (10 tries)
What to do:
Try another calibration method, if still no luck:
1. make full flash backup for emergency case
2. make "format ffs"
3. Power-On phone
4. Power-Off phone by "Power" button (do NOT remove battery)
5. Repeat "Calibration" operation again
6. if still no luck read full flash and send to support with subject: touchscreen calibration failed
error: can't detect ffs/eeprom structure id
error: operation failed !
Finished, time used: 15 sec
Remove/Install battery now !
Вариант с перепаиванием буду делать в самом крайнем случае.
Есть ли рабочее софтовое решение?
Может, как - то слить калибровки с рабочего аппарата и залить в мой? Если у кого есть такой аппарат, слейте файловую систему Maui. Или сами калибровки, если знаете, в каком файле они...
Или писать на саппорт и ждать следующего миракла, что не вариант...