Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.24, JTAG Manager Version: 1.32
Selected Resurrector: [Samsung S5250]
Connecting to the dead ************...OK
Detected dead ************ ID: 0x07926F0F - CORRECT!
Set I/O Voltage reads as 3.06V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip ID: 0x00EC/0x0050 (512MB)
Selected Resurrection Data for the NAND Chip with Page size = 4KB
Flashing the dead ************...OK
WARNING: Bad Block Error (0x25) at 0x00040000 is handled as Cut Excess.
WARNING: Bad Block Error (0x25) at 0x000C0000 is handled as Cut Excess.
WARNING: Bad Block Error (0x25) at 0x00140000 is handled as Cut Excess.
WARNING: Bad Block Error (0x25) at 0x001C0000 is handled as Cut Excess.
WARNING: Bad Block Error (0x25) at 0x00240000 is handled as Cut Excess.
WARNING: Bad Block Error (0x25) at 0x002C0000 is handled as Cut Excess.
WARNING: Bad Block Error (0x25) at 0x1DD40000 is handled as Cut Excess.
WARNING: Bad Block Error (0x25) at 0x1FF40000 is handled as Cut Excess.
Resurrection complete!
