Infinity новости

[IHelper]

Infinity Chinese Miracle-2 MTK/Mediatek v2.08 - New models and repair features

As ordinary, uniques functions and methods released.

Please do not forget to download new drivers v5.1632_x86_x64 !

Core:
Changed : Loader v1952 supported and tested
BugFix : Rebuild support for MT6572 line ( KaiOs and old devices )
Changed : Automatic selection of higher available BASE loader at startup
Changed : Automatic protocol switching for RAPHAEL line
Changed : Initial META protocol support
Changed : AutomaticBoot selection revised. More types and combinations are supported.
Changed : Protocol updated for RAPHAEL line

New feature : Meta protocol support activated
!*Support Legacy line ( MT6572 .. MT6595 )
!*Support Raphael line ( MT6750 .. MT6797 )
!*Support Modern Raphael line ( MT6761, MT6765 and newer )

Function : Identify ( AP/MD, SWversion info, Security details )
Function : Reset Settings / Format FS ( NOT touch FRP )
Function : Repair security for
Legacy line ( from MT6572 and up to 6580 )
Raphael line ( from MT6570 to MT6765 etc. )

!*Devices with SLA will not work for repair without auth! ( even if Meta started )
!*Devices with OTP will not work for repair! ( SW will just show write error )

Service:
Changed : Format FS procedure updated
BugFix : Identify procedure updated and revised
Changed : eMMC life counter check ( Raphael, more accurate status handling for latest loaders )

UserData:
Changed : Reset Privacy Locks procedure updated

MemoryTool:
BugFix : Long-run reading optimized for RAPHAEL line

Firmware reader:
Changed : Updated support for legacy platforms
Changed : Updated support for MT6739 FP-like and KaiOS phones
Changed : Local database update
Changed : Data verification improved
Changed : More types supported

Flasher:
BugFix : In some cases were made wrong SV5_BL image selection for EMI base
Changed : Protocol updated for RAPHAEL line
Changed : Protocol update for LEGACY line
BugFix : Flash Erase ( whole mode ) revised
BugFix : Flash Pre-Erase ( safe upgrade mode ) revised

Other:
Changed : Boot helper updated. Take attention to software logs and follow them. In most cases that enough to setup correct settings
New feature : Reboot option activated in main tab. Switch charge / power off mode after operations
New feature : META switch option activated in main tab. Used to switch SW between FLASH and META mode
Changed : Loader database updated
Changed : Minor changes in GUI, check buttons/fields hints to know more about alternative modes and special options of supported functions

Info:
META require working device condition. Charged battery (more than 20%). Installed drivers.
New drivers v5.1632_x86_x64 is at support area.

https://www.infinity-box.com/news/?r=3976

[IHelper]

Infinity Chinese Miracle-2 MTK/Mediatek v2.09 - SP-unlock for modern platforms and more

As ordinary, uniques functions and methods released

Core
BugFix : SelfLearning ( Automatic Boot Selection ) feature updated
!*In some cases may require repeat learning for some platforms

New Feature : Enter META from BROM mode
!*Support LEGACY legacy
!*Support RAPHAEL line
!*In case of secure fuse, auth can be used ( setup in model selection, or manual select as AUTH file )
!*May not work in TestPoint cases on some platforms

Service
Changed : Repair security procedure updated (Flash and Meta mode)
Changed : SPUnlock procedure updated (Flash and Meta mode)
Changed : Unlock in Meta mode activated for modern platforms ( MT6739 and newer )
Changed : Identify procedure updated

Firmware Reader
Changed : Improved structure identification
Changed : Support more different types
BugFix : Fixed some old platforms support

MemoryTool
Changed : Path Selection now automatically select files in WRITE FILE fields if they are exists in selected folder

Flasher
BugFix : Fixed flashing for old slow platforms ( MT6735 / MT6580 )

Meta protocol functions updated
Changed : Identify now read all Android info, like in FlashMode
!*Feature will not work on old devices ( Android 4.x, MT6572 and similar legacy chip typess )
Changed : Updated security detection feature
BugFix : Updated different Legacy and Modern platforms support
Modem warmup not cause fatal errors on some old phones
Modem-less devices detection ( wifi tablet / smartwatches )
Changed : Format FS revised
*!Some models can not be reset with that feature ( found in some Oppo )
BugFix : Updated structure verification
Changed : Repair Security rebuild, support more types and non-standard cases

New Feature : SP Unlock
Tested and confirmed as working in LEGACY line ( Teseted with MT6735, MT6580, MT6752, MT6753. Should works on other legacy chip types )
Tested and confirmed as working in RAPHAEL line ( Teseted with MT6739, MT6761, MT6755, MT6750. Should works on other Raphael chip types )
We are looking for user reports and interest test cases

Other
BugFix : Some minor changes and bugfixes

https://www.infinity-box.com/news/?r=3977

[IHelper]

Infinity Data Explorer v1.06 - Android contacts/sms support and more

Data extraction based on full reconstruction of file system

- Contacts and accounts reconstrucion from Android storage contacts2.db
- SMS messages reconstrucion from Android storage mmssms.db
- Data storage engine rebuilded
- TXT file storage format updated
- Minor bugs fixed

[IHelper]

Infinity Data Explorer v1.07 - SPRD engine rebuilded and more

Data extraction based on full reconstruction of file system

- SPRD engine rebuilded
- contacts save method updated
- long SMS parse method updated
- HTML export released (via templates)
- gui: log autoclear option before new operation
- gui: pop-up menus for log (clear and save options)
- folder with date/time creation for Converter
- Minor bugs fixed

[IHelper]

Infinity Chinese Miracle II SCR/SPD-RDA v1.06 - New models and features

As ordinary, unique functions and methods released

Supported CPU list:
Spreadtrum: SC6530, SC6531, SC6531(A/C/D)
SpreadTrum: SC68xx ( with external PAC )
SpreadTrum: SC7702 ( with external PAC )
UniSoc: SC6531E, SC6533, SC6533G, SC7702
RDA Mirco: RDA8851 rev A,B,C,L,CL
RDA Micro: RDA8826

Core
NewChip: Support UNISOC 8910 (FLASH) under test
NewChip: Support IVY IoT (FLASH/SVC) under test
Changed: UpToDate Protocol changes for latest FP platforms ( UniSoc )
BugFix: Connection on SPRD tab
BugFix: BOOTROM mode on latest SC6533G branches

Support UNISOC 8910DM / UIS8910 chipset ( SVC mode )
- Identify ( Security info, compilation info, modem info , APinfo )
- Format FS / Reset Settings
- Read UserCode / PrivacyCode
- Repair Security
!* Generic types only

New Feature: SVC ( Diag ) mode support for SPRD / UniSoc
- Identify ( Security info, compilation info, modem info )
- Format FS / Reset Settings
- Read UserCode / PrivacyCode
- Repair Security
!* Generic types only

Service
BugFix: Security repair not allow use some "non-standard" combinations ( RDA / SPRD / UniSoc )
Changed: CompileInfo extraction improved ( RDA / SPRD / UniSoc )
Changed: GUI revised for repair part ( CS info, Automatic complete at double click for security fields )

UserData
BugFix: Security code read in FlashMode revised ( SPRD )

Other
BugFix: Lot of small different changes and fixes

[IHelper]

Infinity Chinese Miracle-2 SPD/UniSOC v2.05 - NAND, KaiOs and new features

Core
NewChip : SC7731E with NAND ( KaiOS and MocorDroid5 )
NewChip : SC7715x with NAND ( KaiOS , MocorDroid5 , Android 4x)
NewChip : SC9820x with NAND ( MocorDroid5 , Android 4x)
Protocol : Speed increased for most operations ( SPD and UniSOC )
Protocol : Protocol changes according SPD/UniSOC R23 line

New Feature : NAND support ( SPD and UniSOC generation )
!* Support flashing Factory / InfinityFW
!* Support correct flash selection and servicing phones with NAND
!* Support InfinityFW reading ( Complete, Factory-Like )
!* Support Service operations

Service
Changed : Repair security procedure updated (Flash and Diag mode)
Changed : Identify procedure updated
!* Support complete and fast NAND devices identification
!* Support complete simlock info structure identify and verify
!* Support multi-nv structure detection and security info detection
!* Database update / self-learning updated
!* FileSystem identification support UBIFS and F2FS detection
Changed : Format FS / Reset FRP procedure updated

Firmware Reader
New Feature : NAND support
!* Support old and new generations ( SPD and UniSOC )
!* Support plain Android , KaiOs and MocorDroid5 OS
!* Automatic and correct FileSystem creation for NAND devices
!* Support all security types, include UniSoc secure/signed
!* Produced FW is 100% like factory one
Changed : FileSystem creation engine updated ( UBIFS support , bugfixes )
Changed : Improved structure identification
Changed : Support more different types
Changed : Old SPD line support rebuild ( SC7715,SC7731,SC983x,SC9820x )
Changed : Fixed FW creation in full manual / skip verify mode settings

Flasher
New Feature : Complete flash erase ( whole flash format ) during flashing ( eMMC / NAND )
New Feature : Correct NAND flashing support ( SPD and UniSOC ) ( Factory PAC and InfinityFW )
Changed : Flashing core for InfinityFW more stable

Loader Database
NewChip : SC7715 BASE NAND revisions included
NewChip : SC9820 BASE NAND revisions included
NewChip : SC7731E BASE NAND revisions included
NewChip : SC7731E BASE eMMC LOW_MEM revisions included ( cheap A8-A9 devices )
NewChip : SC7731x BASE eMMC LOW_MEM revisions included ( old A4-A5 GEA devices )

Other
Changed : Manual mode : automatic structure and setting detection in manual mode
Changed : Automatic base settings selection for BASE loaders ( Protocol, Charging, FlashSettings )
Changed : Separate NAND mode option activated in platform settings for manual mode
BugFix : Lot of minor changes and bugfixes
Changed : Software compatibility with other applications improved


Тянуть, как обычно, ТУТ и распаковывать, как обычно, с паролем 12345678

[IHelper]

Infinity Chinese Miracle-2 MTK/Mediatek v2.10 - New MTK chips and UFS storage

As ordinary, unique functions and methods released

Core
NewChip: Helio G90T (Formely MT6785) supported (UFS / eMMC)
NewChip: MT6731 supported (eMMC / NAND)
NewChip: Helio A20 (Formely MT6761 low-cost revision) supported
NewChip: Helio P90 (Formely MT6779) support under test (UFS / eMMC)
BugFix : MT6595/MT6597 BROM support broken, fixed (Agent 17xx-19xx)

New Feature : UFS FlashIC support
!* Support flashing Factory / Infinity FW
!* Support MemoryTool
!* Support Factory Firmware reading
!* Support Service operations
!* SOC's on market, support UFS chips right now : G90, P70, P90

Service
Changed : Repair security procedure updated (Flash and Meta mode)
Changed : SPUnlock procedure updated (Flash and Meta mode)
Changed : Identify procedure updated
Changed : Format FS / Reset FRP now support UFS flash too
New Feature : Modem Re-Init (NVfix)
!* Useful after FixBB, in case of modem subsystem alive

Firmware Reader
New Feature : UFS flash support
New Feature : Combo scatter creation for newest chipset
!* Produced scatter MAY NOT work with OLDER SPFT (factory flasher) below 19xx versions!
!* Produced scatter is 100% like factory ones
Changed : Improved structure identification
Changed : Support more different types
Changed : NAND support revised
Changed : LEGACY line support revised
Changed : Platform and version depend scatter creation for better compatibility with SPFT
Changed : LEGACY line with Android 9 (MT6580 and similar) specific changes

MemoryTool
New Feature : UFS flash support
!* Support Read , Write , Erase partitions
!* Support RePartition
!* Support Preloader init
!* Support Change Work mode (ADR / PRT)
!* Change storage settings useless, all flash content mapped in single mode
Changed : Structure identification
Changed : Automatic files selection at folder change

Flasher
New Feature : Support COMBO scatter's (v2.xxx)
!* Automatic selection depend on device Flash (UFS/EMMC/NAND)
!* Storage selection done automatic according detected, for end-user all selection and rest settings remain same as before
New Feature : Support MTK chips with UFS FlashIC flashing
!* All features (Erase / Verify / PMT upgrade / Backup / HW Compatibility) work for devices with UFS as well
Changed : Scatter tab changes, specific to multi-storage selection and settings

Meta protocol functions updated
Changed : Updated security detection feature
BugFix : Updated structure verification

Other
BugFix : A lot of minor changes and bugfixes applied
Changed: Many internal changes to improve compatibility with other applications, antiviruses and similar software.
Changed: Software load/operation speed improvements implemented


Файлы ТУТ

[FARIC]

С Meizu эта штука работает ?

[IHelper]

С Meizu эта штука работает ?

Примерный список моделей тут - https://www.infinity-box.com/
Подробнее список фактически протестированных моделей можно найти тут - https://www.infinity-box.com/support/?r=8

[IHelper]

Infinity Chinese Miracle-2 MTK/Mediatek v2.11 - New features activated

Подробно тут - https://www.infinity-box.com/news/?r=4000

[IHelper]

Infinity Chinese Miracle-2 RKT/Rockchip v2.02 - New chips and latest Android support

Подробно тут - https://www.infinity-box.com/news/?r=4003

Надо ставить новые RKT драйвера - https://www.infinity-box.com/news/?r=4002

[IHelper]

Infinity Chinese Miracle-2 MTK/Mediatek v2.12 - F2FS support, EncryptInfo and more

Подробно тут - https://www.infinity-box.com/news/?r=4009